Fall Arrest; Operation; Pre-Operations Check - Eddyfi Technologies Magg 310 Manual

Fall Arrest

IMPORTANT: A lifeline or fall arrest system should always be used when vehicle detachment
from the working surface threatens injury to personnel or damage to equipment. A fall arrest
system can be attached to the vehicle on either or both chassis handles.
Additionally, one of the handles may be relocated using the two mounting holes located behind
the camera.

Operation

Pre-Operations Check

Before each deployment of the Magg™ 310 system, ensure everything is completed on the following
checklist.
❑ Check that the work area has been safely set up.
❑ Fall arrest is in place for vertical or inverted use.
❑ Check that the line voltage available at the worksite matches the equipment setup.
❑ Check that power and deck cable connections are correct.
❑ Check the vehicle for the following:
 Check that the vehicle is in the correct configuration for the deployment.
 Check the vehicle for mechanical damage to the chassis or cable harnesses which could affect its
operation.
 Ensure that all fasteners are in place and secure. In particular, check the fasteners holding on
cameras, lights, tracks, and the harness block.
Document: umed018307
Source Location: C:\epdm\isleng\products\ed-magghd\manuals\umed018307.docm
Revision: A01 Created by: ST
Magg™ 310
Date: 24 Feb 2021 IPN: 3097222-A01
Page 22 of 30