Vehicle Configuration; Camera Mounting; Standard Mounting - Eddyfi Technologies Magg 310 Manual

Vehicle Configuration

Camera Mounting

The Magg™ 310 camera can be mounted in a standard configuration or can be removed from the vehicle
and mounted on an accessory pole. The camera can also be mounted in an alternate orientation option.

Standard Mounting

To install the camera onto the vehicle, do the following (removal is the reverse of installation):
1. Make sure the starboard axle screw is fully disengaged (tip should be slightly recessed in round
housing).
2. Slide the camera between the chassis fairings, make sure the connector is oriented as shown
and the washer is located with the locking nut on the outside of the fairing (see below).
3. Making sure the connector stem is seated all the way down in the port fairing slot, tighten the axle
screw; make sure it cleanly enters the bronze bushing in the camera head.
4. Tighten the port side locking nut.
5. Connect the camera whip to the bulkhead connector.
Document: umed018307
Source Location: C:\epdm\isleng\products\ed-magghd\manuals\umed018307.docm
Revision: A01 Created by: ST
Magg™ 310
Date: 24 Feb 2021 IPN: 3097222-A01
Page 18 of 30