Rinsing And Cleaning; Fuse Replacement - Eddyfi Technologies Magg 310 Manual

Rinsing and Cleaning

After every mission check to see if the vehicle needs cleaning.
1. If the system has been used in salt water, thoroughly rinse the vehicle with fresh water prior to
being stored away. Accelerated corrosion will result if the inspection system is not rinsed properly.
Pay close attention to rinsing and cleaning the camera window, LED light dome and the spaces
between moving parts and track belts.
2. Use an open hose or tap at regular water line pressure for rinsing. Do not pressure wash the
equipment – water will be forced into the camera at these high pressures.
3. Avoid scratching the camera port. Use glass cleaner and a soft cloth to clean the port.
CAUTION: Do not use a pressure washer to clean the vehicle or system
components. Very high-pressure water can push past seals and flood the
components resulting in electrical damage or personal injuries.
Periodically:
1. Use a damp cloth or spray cleaner for the power supply / controller box. The box must never be
sprayed down or immersed in water. Unplug the controller before cleaning.
2. For general cleaning of the cameras and tracks, use a mild detergent.

Fuse Replacement

Document: umed018307
Source Location: C:\epdm\isleng\products\ed-magghd\manuals\umed018307.docm
Revision: A01 Created by: ST
Magg™ 310
Date: 24 Feb 2021 IPN: 3097222-A01
Page 25 of 30