Control Panel : Network Settings : Tcp/Ip Settings Page : Create Teaming : Balance Round Robin; Control Panel : Network Settings : Tcp/Ip Settings Page : Create Teaming : Dynamic Link Aggregation (Ieee 802.3 Ad); Control Panel : Network Settings : Tcp/Ip Settings Page : Create Teaming : Balance Tlb; Control Panel : Network Settings : Snmp Protocol Settings Page - American Megatrends StorTrends 1100-P User Manual

Control Panel : Network Settings : TCP/IP Settings Page : Create Teaming : Balance Round Robin

This option transmits packets in sequential order from the first available slave-NIC in the
team through the last. This mode provides load balancing and fault tolerance.
Control Panel : Network Settings : TCP/IP Settings Page : Create Teaming : Dynamic Link
Aggregation (IEEE 802.3 AD)
Creates aggregation groups that share the same speed and duplex settings. Requires a
switch that supports IEEE 802.3ad Dynamic link aggregation.

Control Panel : Network Settings : TCP/IP Settings Page : Create Teaming : Balance TLB

Adaptive transmit load balancing: channel bonding that does not require any special
switch support. The outgoing traffic is distributed according to the current load
(computed relative to the speed) on each slave-NIC in the team.

Control Panel : Network Settings : SNMP Protocol Settings Page

The SNMP Protocol Settings page allows you to Enable SNMP and to input the
Community Name.
Field/Item Description
Enable SNMP Left click this box to enable Simple Network Management Protocol (SNMP). SNMP is a
network protocol used to manage TCP/IP supported systems. This protocol provides
functions that enable you to access data objects whose definitions are located in the
Management Information Base (MIB).
Note:
SNMP compliant devices, called agents, implement the various system-related MIBs.
They also implement the AMI ManageTrends software MIB. For all supported MIBs, an
agent can send information to the SNMP requester.
To send SNMP traps, the SNMP protocol does not need to be enabled.
Community Name Enter the community name that your network uses.
A community name is a secret identity based on plain-text that is used to authenticate
queries to agents of managed network devices. A read-only community name allows
systems to gather statistics from your SNMP device. The most commonly used community
name is public.
Note:
Apply button To save changes, left click the Apply button. To cancel without saving changes, left click
the Close button.
The latest MIB for the StorTrends iTX software can be found on the StorTrends
software CD.
By default, the ManageTrends® Management Suite can discover your Storage
Appliance only if the community name is set to public and SNMP is
.
enabled.
Chapter Two : Managing the ManageTrends Storage Appliance 33