Piper Comanche PA-24 Service Manual page 542

PIPER COMANCHE SERVICE MANUAL
A .. '
FIGURE 78-7_ FUEL AIR BLEED NOZZLE
NOTI
Do not exceeel 60 inch"?ouncis torque on nozz.lc. when Iligning
air
bleeel
hole.
d. Connect fueJ line to nozzle.
CAUTION
Start nozzle. and line <ouplings by hand to prevent the po .. ibility of
c:ro .... hreading.
e. IIlSUil engine cowling.
78-37. Ignition Sy ... m MaiD_a.
78-38. Inspection Of .\\opeto.
L
Remove harness a.sscmbly cover from magneto and inspect pam for moisture, broken leads or
other dunage.
b. Swing leads out of outlets in disaibutor blook and remove <wo screws ,.cunng block in hou.mg.
Lift the block from magneto.
c. To properly inspect the breaker computment and breaker points. it will be necessary
[0
remove
the disaibutor iinger by removing the <wo attaching screws and
washon.
d. Inspect breaker points for excessive wear or burning. Desired contact IUrfa.ca will have a dull gray
sandblasted or frosted appearance. Minor irregularities or roughness of point surfaces ue not harmful.
2 F12
POWER PLANT
ISSUED: 8/18/72_