Piper Comanche PA-24 Service Manual page 473

PIPER COMANCHE SERVICE MANVAL
Connect bonding straps to engine and engine mount
J
Connect throttle and mixture controls and adjust per paragraphs 7A-52 or 7A-61
I.
Connect carburetor heat control and adjust per paragraph 7 A-52.
I Connect go\ernor control cable
to
governor and secure with clamps
m Install carburetor inlet fuel line and fuel pressure line
n I nsta II oil cooler lines
o Connect fuel lines to engine driven fuel pumps
p Install spark plug leads and clamp.
q Connect engine breather hose to engine accessory housing
r Connect oil temperature wire to accessory housing.
s. Connect tachometer cable to fitting on engine accessory housing.
t Connect magneto .. p" leads
to
magnetos. and safety
u. Connect manifold pressure line to
"0
6 cylinder
\ Connect primer line
\\. Connect cylinder head temperature wire to 1\0 5 cylinder
x Connect oil pressure line
to
engine accessory housing
\. Connect air oil separator drain hose to engi.,·, 1ccessory housing.
7
Connect vacuum hose to vacuum pump
aa Install air duct on muffler shroud and right rear baffle
abo Install fuel pump blast tube
ac Install propeller (Refer to paragraph 7A-14 or 7A-17)
ad Install the proper grade and amount of engine oil
'OTE
Refer
10
latest Lycoming Sen'ice Instruction
'\0
1241
ae Install engine cowling (Refer
10
paragraph 7A-7)
af Connect
batter~
ground cable. turn fuel seleclOr \alve on and turn on
auxiliar~
fuel pump Check
,
,
for fuel leaks
RE\'ISED:
4/10/81
2C19
POWER PLA"T