Piper Comanche PA-24 Service Manual page 375

PIPER COMANCHE SERVICE MANUAL
1 OUTER WHEEL HALF
2 INNER WHEEL HALF
3 BEMING cuP
4 BEARING CONE
6 GREASE SEAl RETAINER
8 GREASE SEAL. FELT
7 BOLT
8 NIJT
9 WASHER
10 SNAI' RING
11 .IIAKE DISC
MINIMUM DISC THICKNESS'
MEASURED AT 3 POINTS
TO GET AVERAGE
DISC PIN MIN
"1M-19
= 127
"1M-UA • 34.5
FIGURE 5-28. MAIN WHEEL ASSEMBLY (CLEVELAND) PA·24-280 lad PA·24400
e. On PA·24-ISO and PA-24-2'O airplanes. insWl the wheel .. fOUOM (Refer to Figure 6-25),
1. Tbe wheel may be installed by
f1exmc
the fork eno"lh to allow for installation of wheel and
spacer tubes.
2. Insert the ule tube. fork caps and tie bolt.
3. Adjust tie bolt nut to allow the wheel to
tum
freely yet not fit loose on the lXie.
f. On PA-24-260 and PA-24-400 airplanes. install the wheel .. foUo .... (Refer to Figure 6-26),
I. Slide the wheelan the ule.
2. Tighten the axle nut to allow the .. heel to tum freely yet not fit loose on the axle.
3 Saiety the lXie nut and in.wl dust cover.
g. Install the brake assembly by positioning tbe brake lining back plates between the wheel and brake
disc and the brake cylinder on the torque plate. Insert the spacer block and shim between the back plates
and cylinder, and install the four bolts to secure the assembly. If the brake line w .. disconnected, reconnect
rhe line and bleed the brakes. (Refer to paragraph 6-8S.)
6-74. Removal And Di ....... mbly Of MaiD G ... Wheel. (GoodrichlPA-Z4-400 (Reier to Figure 6-27 )
a. To remove the wheel a.uembly. remove the snap (12) secunng the dust cover (ll), remove the dust
cover
b Remove the coner pin and axle nut. The wheel may be removed from the axJe with the !:>rlke disc
renw.mn@: with the brake assembly.
lK9
LANDING GEAR AND BRAKE SY!:TEM
Revised: 9 10,79