4-6. Removal Of Landing Light And Housing. (Refer to Figure 4-1.)
A. Remove wing tip.
B. Remove the sheet metal screws from the landing light window assembly (1).
C. Remove the machine screws and clamps (2) holding the lamp (3).
D. Pull the lamp forward and remove the electrical leads (4) from rear of the lamp; then remove the
clamp.
E.
To disassemble the landing light housing, remove the screws located in the corner of the housing.
F.
Make sure that the electrical leads to the lamp are disconnected prior to removal and that the lamp
is not dropped when the front clamp and rear bracket are separated.
4-7. Removal Of Aileron.
A. Disconnect the aileron control rod at the inboard aileron hinge.
B. Remove the hinge bolts, keeping track of the location of the spacer washers.
C. Pull the aileron straight off the wing to allow the counter-weight to clear.
IV - STRUCTURES
PIPER COMANCHE SERVICE MANUAL
Figure 4-1. Landing Light Installation
1E6
04/01/09