Piper Comanche PA-24 Service Manual page 159

TABLE III-I. INSPECTION REPORT - PA-24 / PA-24-250/260/400 (cont.)
NATURE OF INSPECTION
18. Inspect switches to indicators registering fuel tank quantity .................................
19. Inspect fuel cell vents.............................................................................................
20. Reinstall inspection plates and fairings..................................................................
G. LANDING GEAR GROUP
1. Inspect oleo struts for proper extension and evidence of fluid leakage.
(See Landing Gear, Section II.)..............................................................................
2. Inspect nose gear steering control..........................................................................
3. Inspect wheels for alignment .................................................................................
4. Put airplane on jacks ..............................................................................................
5. Inspect tires for cuts, uneven or excessive wear and slippage ...............................
6. Remove wheels, clean, inspect and repack bearings..............................................
7. Inspect wheels for cracks, corrosion and broken bolts ..........................................
8. Check tire pressure. (Refer to Section II.) .............................................................
9. Inspect brake linings and discs for condition and wear. (See Note 21.) ................
10. Inspect brake backing plates for cracks .................................................................
11. Inspect hydraulic lines, electrical leads, and attaching parts for condition
and security (i.e. - routing, chafing, damage, wear, etc) ........................................
12. Inspect condition of shimmy dampener .................................................................
13. Inspect gear forks for damage................................................................................
14. Inspect oleo struts for fluid leaks and scoring .......................................................
15. Inspect gears struts, attachments, torque links, retraction
links and bolts for operation. (See Note 11.) .........................................................
16. Inspect gear doors and attachments. (See Notes 16, 17 and 18)............................
17. Inspect warning horn and light for operation.........................................................
18. Retract gear - Check operation ..............................................................................
19. Retract gear - Check doors for clearance and operation ........................................
20. Inspect emergency operation of gear. (See paragraph 6-107.)................................
21. Inspect landing gear motor, transmission and attachments....................................
22. Inspect Landing Gear Transmission Retract Spring for condition,
security and operation. (See Figure 6-13, Item 14 or 15.) .....................................
23. Inspect anti-retraction system ................................................................................
24. Inspect position indicating switches and electrical leads for security ...................
25. Inspect rubber assist bungee cords and check bungee arms
for wear, cracks and/or deformation. .....................................................................
26. Lubricate per lubrication chart in Section II ..........................................................
27. Remove airplane from jacks ..................................................................................
04/01/09
PIPER COMANCHE SERVICE MANUAL
1D21
Inspection
Interval (Hrs)
50 100
O
O
O
O O
O
O
O
O
O
O
O O
O O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
III - INSPECTION