Multi-Sheet Feeder - Formax FD 380 Operator's Manual

MULTI-SHEET FEEDING
The multi-sheet feeder is designed to fold pre-collated stapled or unstapled sets of up to three 20 # sheets of
paper.
1. Adjust the side guides on the feeder for the proper
paper size. Loosen the brass thumb screw. Open or
close the guides to fi t the paper width and re-tighten
the thumbscrew (Fig 10a).
2. Slide the pre-collated paper set into the multi-sheet
feeder. When feeding stapled sets the documents
should be placed with the staple on the operator's
side and leading (Fig 11).
Fig 10b
Fig. 10a
Brass thumbscrew
Skew Adjuster
3. The sheets of paper will be automatically pulled into
the folder (there is a one second delay after the paper
is placed in the feeder).
4. If the fold is skewed, turn the skew adjustment knob
located on the back of the feeder left or right to make
corrections (Fig 10b).
5. To remove the multi-sheet feeder depress the
release levers located on either side of the lower back
side of the feeder (Fig. 12), tilt the feeder forward and
lift. To reinstall depress the levers and reinsert.
Fig. 11
Staple
Fig. 12
Release Levers
7