NEC Express 5800 Series Maintenance Manual page 139

Chapter 3 Appendix
(3) Error messages on a virtual LCD
You can confirm the error messages by the EXPRESSSCOPE Engine 3 (BMC) web browser window. For
details, see "EXPRESSSCOPE Engine 3 User's Guide".
The table below shows the error messages displayed on upper and lower lines, descriptions, and recommended
actions.
•
Messages displayed on an upper LCD line
BIOS Message on
Upper LCD Line
XX POST Started... POST is running. "XX" is the POST
XX BIOS Rev YYYY
POST Completed
Successfully
POST ERROR XXXX
No Available
Memory in System
Error Pause in POST An error occurred during POST.
Entering BIOS
SETUP MENU
Waiting for normal
temperature
BIOS Recovery
Running
BIOS Updater
Running
Description
running code.
POST is running. "XX" is the POST
running code. "YYYY" is the system
BIOS version.
POST completes normally.
Error XXXX was detected during
POST.
No available memory in the server.
Running BIOS SETUP MENU.
A temperature abnormality was
detected inside the server.
BIOS recovery is in progress.
BIOS update is in progress.
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
Message displayed on
upper LCD line
Message sent from BIOS
Message displayed on lower
LCD line
Message sent from BMC
Action
This is not an error.
This is not an error.
This is not an error.
Check the error message which appears on-screen,
and take the appropriate action for each error.
Make sure that the memory is correctly installed.
Check the error message which appears on-screen,
and take the appropriate action for each error.
This message disappears when SETUP operation is
completed.
Lower the room temperature or turn off the power to
cool the server to room temperature before starting up
the server. If this abnormality continues to occur,
check if a cooling fan has failed. If the same error still
continues to occur, contact your sales representative.
Wait until the BIOS recovery process completes.
Wait until the BIOS update process completes.
1. POST Error Message
(1/2)
139