Configuring Oryx Setup; Configuring The Camera Driver - FLIR ORYX R Installation Manual

5

Configuring Oryx Setup

After successful installation of your camera and interface card, you can make changes to the setup. Use the tools
described below to change the IP Address or the driver for your interface card.
For information on updating your camera's firmware post installation, see
5.1

Configuring the Camera Driver

For the Oryx camera, ensure that PGRLWF driver version 2.7.3.92 or above is installed.
The PGRLWF driver should already be installed automatically using the Spinnaker SDK installer when the Camera
Evaluation option is selected. Or in the case of Application Development option, the driver is installed if you select the
GigE Driver checkbox.
Alternatively, you can manually install the driver. The PGRLWF files are located in:
C:\Program Files\Point Grey Research\Spinnaker\driver64
To verify your driver:
1. Launch SpinView:
Start-->All Programs-->Point Grey-->Spinnaker SDK-->SpinView
2. Select the camera.
3. In the Feature tree search box, enter "driver". The Device Driver Version feature is highlighted.
4/9/2020
©2015-2020 FLIR
Integrated Imaging
Solutions Inc.
All rights reserved.
Camera
®
FLIR Oryx Installation Guide
5 Configuring Oryx Setup
Firmware.
9