Honeywell PRIMAIR 800 Series User Instructions page 8

TROUBLE SHOOTING GUIDE ___________________________________________________________________________________________________________________________________________________________________________________________________
ADF does not darken
Protection level too bright
Protection level too dark
ADF Flickering
Poor Vision
WARRANTY ____________________________________________________________________________________________________________________________________________________________________________________________________________________
HONEYWELL RESPIRATORY SAFETY PRODUCTS cannot, in general terms, accept responsibility for damage incurred by the owner, user, other persons using the safety product or third parties, which results either directly or indirectly from
incorrect use and/or maintenance of the safety product, including use of the product for any purpose other than that for which it was supplied and/or the non-compliance or incomplete observance of the instructions contained in this user
manual and/or in connection with repairs to the safety product which have not been carried out by us or on our behalf.
HONEYWELL RESPIRATORY SAFETY PRODUCTS will repair or, if necessary, replace this product free of charge in the event of a material or manufacturing defect within 12 months of the purchase date, provided that the product has only
been subjected to normal usage in accordance with the user instructions. The warranty is invalidated if the type or serial number marking is modified, removed or made illegible.
APPROVALS ____________________________________________________________________________________________________________________________________________________________________________________________________________________
Product as a part of the powered air purifying system, complies with the European Parliament and Council Regulation 2016/425/EU for Personal Protective Equipment and subsequent amendments.
The EU type-examination as per Module B (EN 12941:1998 + A1:2003 + A2:2008 ) of PPE Regulation as well as the production process based on quality assurance of the conformity to type set out in Module D of PPE Regulation are
under surveillance of the notified body number 0082:
APAVE SUDEUROPE SAS - CS60193
13322 MARSEILLE Cedex 16 - FRANCE
The EU type-examination as per Module B (EN 175:1997, EN 379:2003 + A1:2009, EN 166:2001) of PPE Regulation of helmet's face shield, automatic welding filer and front cover lens was issued by the notified body number 1883:
ECS European Certification Service GmbH – Hüttfeldstraße 50
73430 Aalen – GERMANY
The complete declaration of conformity can be found at: https://doc.honeywellsafety.com/
PROBLEM
Increase the sensitivity.
Change the sensor slider position.
Deactivate grinding mode.
Remove any blockages or debris in front of the sensor.
Clean the sensors or replace the front lens cover.
Replace the batteries.
Adjust the shade level lower.
Adjust the shade level higher.
Clean or replace the front lens cover.
Adjust the position of the delay knob.
Replace the batteries.
Clean or replace the front lens cover.
Adjust the protection level.
Increase the ambient light.
CORRECTION
EN-3