1.2
Device delivery
1.2.1
Checking the delivery (list of supplied and required parts)
1.2.2
Transporting and storing the device
Unpack the measuring instrument and any other components and check them for
signs of damage and missing or incorrect parts. Use your order documents and the
information in this manual as a guide for this purpose. The device is supplied ready-
assembled with all interior components and includes the required connections and
potential connections for gas, electricity and signals in standard operation unless
otherwise ordered. You should therefore check the following points:
Every gas connection must be fitted with a Swagelok pipe fitting with a suitable
•
thread or a blind plug.
Every electrical connection must be fitted with a cable gland of a suitable size
•
or a blind plug.
There are not normally any openings on the device that do not have plugs or
•
fittings/glands.
The local display is included (optional, if ordered).
•
Fastening materials, for example wall mounting bracket with screws, are
•
included as ordered.
Prevent transport damage, incorrect storage. Please also refer to the liability
information at the start of this manual.
Store the device in a clean, dry location. Prevent dirt getting inside it. Pre-
vent material damage caused by the formation of condensation and
ATTENTION
corrosion
The following applies to storage:
The ambient conditions (see chapter „ Technical spezifications ") must be
•
maintained.
The packages may only be stored in enclosed rooms.
•
Avoid mechanical impacts during storage.
•
The storage time with a battery is up to one year, 2 years if the battery is then
•
replaced.
EnCal 3000 Hardware Manual
ABOUT THIS MANUAL AND DEVICE DELIVERY
73022344 o
10