Rail M Ounting And Assem Bly Of The Loops - SpaceraiL Spacewarp Level 9.1 Instruction Manual

17
In sta lla tio n o f th e ra ils
A ttachm ent of rails to arm s and shafts
(fg . 37 + 38)
A ttach rail to arm (fg . 37)
Rail joining (fg . 39)
A djust and connect the rails. Insert the rail
joining s [R2] into the holes at the center of
the rails (fg . 39)
Inform atons about rail stands (fg . 40)
T he distance betw een the arm s should be
betw een 8 to 10cm to ensure best stability .
W hen the distance is larg er, rail stands [A 6]
hav e to be installed
A ttach rail stands in steep sections and
elev ator entry /ex it points to ensure best
stability of the rails
Steep sections (fg . 41)
Install the arm s in an inclined position to
each other to create steep sections, so that
the steel balls can run sm oothly (fg . 41)
18
In sta lla tio n o f a lo o p
Ensure the steel balls running sm oothly
(fg. 42)
T he diam eter of the outer loop should hav e
tw ice the diam eter of the inner loop
Im portant inform ation for the assem bly of
loops (fg. 43)
Rails hav e to form a circle that rem ains in
an upright position to ensure the steel balls
running sm oothly (fg. 43)
Installation of a loop (fg. 44)
W hen m ounting loops, the second loop has
to be sm aller than the frst loop to ensure
the steel balls running sm oothly
Installation of pendulum tray and junction
(fg. 45-1 + 45-2)
Insert rail stands into the junction (fg . 45-1 )
Sim ply cut the rails to the correct leng th
(see enlarg ed picture on the right)
Insert rails into the pendulum tray (fg . 45-2)
[R1] Rail
37
Insert rails into arm
39
40
41
T he distance betw een the arm s should be betw een 8 to 10cm . W hen the distance is larg er, rail stands [A 6] hav e to be installed
Install the arm s inan inclined position
to each other to create steep sections
42
Inner looping
Height
45-1
[A 6] Rail stand
[P1] Junction
[A 6] Rail stand
38
[A 1] Arm
[R2] Rail joining
[R1] Rail
Use rail stands like railw ay ties
43
Cut here
Assembly of rails and loop
[R1] Rail
44
O uter looping
In n e r lo o p in g
W hen m ounting loops, the second loop has to
be sm aller than the frst loop to ensure the steel
balls running sm oothly
45-2
[Ex 7] T ray for steel balls
17