A Ssem Bly Of The Elev Ator (Entry And Ex It) And Rail M Ounting - SpaceraiL Spacewarp Level 9.1 Instruction Manual

21
In sta lla tio n o f e le v a to r
(e n try & e x it)
Im portant inform ation for the
assem bly of elev ator entry and ex it
(fg . 52)
Steel balls w ill not run correctly if
entry and ex it point in the sam e
direction
Pay attention to a proper installation
of the entry and ex it (fg . 53)
Install rails as closely as possible
to the entry and ex it of the elev ator
to ensure the steel balls running
sm oothly (fg . 53)
Pay attention to a correct ang le of
the rails w hen the steel balls enter
the elev ator (fg . 54-1, 54-2, 55)
Make sure the steel balls enter the
elev ator slow ly . O therw ise they w ill
rebound and fall off the rails
(fg . 54-1)
Steel balls that enter the elev ator
m ay rebound and thow n back onto
the rails after hitting the helix . Pay
particular attention here to the
correct seating of the rails. O therw ise
the steel balls w ill stop and cannot
re-enter the elev ator (fg . 54-2)
A t the entry all rails m ust be at rig ht
ang les to the elev ator (fg . 55)
A ll rails m ust be at rig ht ang les to the
elev ator
22
D ista n ce b e tw e e n ra ils
(fg . 56 )
Install the rail stand to keep rails
parallel (fg . 56)
23
A sse m b ly o f cu rv e s
(fg . 5 7 + 58 )
Curv es need to be assem bled in a
certain ang le to prev ent steel balls
from m issing the turn (fg . 57). If
steel balls m iss the turn, speed has
to be reduced rig ht before the curv e
A djust rails to reduce speed of the
steel balls (fg . 58)
Ex it
52
Ex it
54-1
55
56
57
A djust rails to reduce speed
58
Entry
Entry
54-2
C urv es need to be
assem bled in a certain ang le
Assembly of rails
53
Keep rails parallel
19