Assem Blyof The Arm S And Seesaw S - SpaceraiL Spacewarp Level 9.1 Instruction Manual

3
03
A sse m b ly o f a rm s
1. Assem ble the arm s according
to fg. 03
Caution: Arm holder A (A2) +
arm holder B (A4) are different
107 arm s are needed for the
com plete set-up
04
2. Insert the arm w rench into the
arm holder A and turn it by 90
degrees to fx the arm (fg. 04)
Note: T o m odify the angle of the
arm , release the fx ation frst
3. A ttach the arm to the shaft
(fg. 05): Insert shaft into the
arm holder B and turn the arm
w rench by 90 degrees to fx the
Insert shaft into the arm holder B. D o not
arm (fg. 05)
apply force in order to av oid dam ages
Note: T o m odify the angle of the
arm , release the fx ation frst
4
06
A ss e m b ly o f s e e s a w
Insert 2 x 75m m rail into the holes
of the seesaw . T hen attach the rail
stand to the seesaw (fg. 06)
07
A ttach seesaw to the shaft
(fg. 07 + 08)
1. Connect seesaw w ith arm holder
B (fg. 07)
2. A ttach arm holder B to the shaft
(fg. 08). Refer to the assem bly
of arm s (E1-E6). Insert arm
[A4] Arm holder B
w rench into arm holder and turn
it by 90 degrees (fg. 03).
Note: T o m odify the angle of the
arm , release the fx ation frst
[A4] Arm holder B
T op-dow n v iew
[A 5] Arm w rench
05
[Ex 1] Seesaw
Mount left hand side
Install 1 pc
[A3] Arm tube
H ole profle
Mount right hand side
1 Stück aufbauen
Install 1 pc
[A3] Arm tube
Length: 75m m
[A 6] Rail stand
08
H ole profle
H ole profle
H ole profle
Assembly of arms & seesaws
[A 1] Arm
[A2] Arm holder A
T op-dow n v iew
Note: W hen turning the arm w rench, m ake sure not
to change the right position of the arm
Note: W hen turning the arm w rench, m ake sure not to
change the right position of the arm
Refer to the assem bly of arm s (page E1-E6)
Adjust seesaw after assem by
Note: W hen turning the arm w rench, m ake sure not
to change the right position of the arm
7