Assem Blyof The Pendulum And The Elev Ator - SpaceraiL Spacewarp Level 9.1 Instruction Manual

Assembly of pendulum and elevator
5
09
In s ta lla tio n o f th e p e n d u lu m
Connect attachm ent parts w ith
pendulum (fg. 09)
Note: T o m odify the position of arm
holder B, release the fx ation frst
6
In sta lla tio n o f th e e le v a to r
1. Insert the 300m m shaft into the
gearbox (fg. 10-1)
2. Slide the elev ator (12 pcs) onto
the shaft (fg. 10-2). Insert shaft
into base (fg. 10-1)
Please note the correct direction
of rotation
3. Insert 3 further 300m m shafts
into the ex act pre-defned
positions on the gearbox (fg.
10-3)
4. A llow the 3 shafts to snap into
place (pic. 10-4). T ake care that
the elev ator rings are properly
located. See page E1 for the
proper locations of the elev ator
rings
5. Insert the 4 shafts into the
elev ator cov er (fg. 10-5). T ake
care that the shafts are properly
located
6. Now attach rail stands [A 6] to
the elev ator ring (fg. 10-6)
8
[A4] Arm holder B
[S1] Shaft 600m m
[A 5] Arm w rench
[Ex 5] Ball catcher
10-1
[S3] Shaft 300m m
[G 1] Antrieb
[G 1] G earbox
10-4
Make sure conv ex red parts point up
and ev erything is correctly seated
[E2] Elev ator ring
[A 5] Arm w rench
[S6] Shaft 65m m
[A4] Arm holder B
[Ex 2] Pendulum
[S4] Shaft 200m m
Refer to the assem bly of arm s (fg. 05)
10-2
[E1] Elev ator helix
Please note the correct
direction of rotation
Av oid that there is a gap
betw een gearbox and
elev ator helix . O therw ise
the elev ator w ill not
operate properly
10-5
[E3] Elev ator cov er
[Ex 6] Counterw eight
[S6] Shaft 65m m
T he counterw eight position is
adjustable on the shaft if the
pendulum does not w ork properly
Note: T o m odify the position of
counterw eight, release the
fx ation frst
[S3] Shaft 300m m
10-3
10-6
[A 6] Rail stand
[A 6] Rail stand
[A4] Arm holder B
[A 5] Arm w rench
[A 6] Rail stand
[A 6] Rail stand