Assembly Of The Elevator - SpaceraiL Spacewarp Level 9.1 Instruction Manual

7
In s ta lla tio n o f th e e le v a to r
1. Insert the 391m m shaft into
the gearbox (fg. 11-1)
2. Slide the elev ator (16 pcs)
onto the shaft (fg. 11-2)
3. Insert 3 further 391m m shafts
into the ex act pre-defned
positions on the gearbox
(fg. 11-3)
[S2] Shaft 391m m
4. Allow the 3 shafts to snap into
place (pic. 11-4). T ake care
that the elev ator rings are
properly located. See page E1
for the proper locations of the
elev ator rings
5. Insert the 4 shafts into the
elev ator cov er (fg. 11-5).
T ake care that the shafts are
properly located
6. Now attach rail stands [A 6] to
the elev ator ring (fg. 10-6)
Make sure conv ex red parts point up and ev erything
is correctly seated
[E2] Elev ator ring
11-1
[G 1] G earbox
11-4
11-2
[E1] Elev ator helix
Av oid that there is a gap betw een
gearbox and elev ator helix . O therw ise
the elev ator w ill not operate properly
[E2] Elev ator ring
11-5
[E3] Elev ator cov er
[A 6] Rail stand

Assembly of the elevator

[S2] Shaft 391m m
11-3
Please note the correct direction
of rotation
[A 6] Rail stand
[A 6] Rail stand
11-6
[A 6] Rail stand
9