Rail Assem Bly Steps - SpaceraiL Spacewarp Level 2.1 Instruction Manual

Assembly of the rails
7
R a il a sse m b ly ste p s
T his ball roller coaster prov ides 2 elev ator ex its (start)
and 2 elev ator entries (end). Please note fg . 12+ 13
and the pictures on page 2+ 3 during assem bly
In stall rail stands tog e ther w ith the rails (pag e 9)
D ue to the long distance, the installation of this
section is div ided into 2 assem bly steps (please
refer to fg. 12-1 + 12-2)
Fig . 12- 1 an d 12-2 sh ow th e u ppe r an d low e r track lay ou t
Fig. 12-1: From elev ator ex it (start) to the loop entry
Fig. 12-2: From loop entry to low er elev ator entry
Install 2 x 245cm rails for the com plete distance
in fg. 12-1 + 12-2
T he enlarged picture prov ides further inform ation
regarding loop installation
From elev ator ex it (start) to seesaw entry : Install 2 x
105cm rails (fg. 13-2)
Fig . 13-1 an d 13-2 sh ow th e u ppe r an d low e r track lay ou t
Note:Fig . 27 on pag e 11 prov ides further assistance if
the steelballs do not run sm oothly into the elev ator
8
12-1
12-2
Loop (enlarged picture )
13-1
13-2
14
Correct seesaw installation
Sim ply cut the rails to the desiredlength (see page 9: Rail joining)
Rail connection m arks
Release arm tube [A 3] before m ounting the rails
Letters and num bers (e.g. D -2) show the correct
positions of shafts and arm s described on page 6-7
D on ´t cut
D on ´t cut
From seesaw ex it (start) to elev ator entry:
Install 2 x 26cm rails (fg. 13-1)
Insert rail stand at the end of
the rail to ensure best seesaw
stability
Seesaw (enlarged v iew )