Table of Contents
Advertisement
Sensormatic
SENSORVISION SYSTEMS
Required Parts
Required Parts
Required Parts
Pendent Mount Kit
0351-0392-01
Description
Flange, 1-1/4" dia.
Fitting, pipe tee
Nipple, short 1-1/4
Anchor bolt, 1/4x2-1/4
w/hardware
Pipe, 1-1/4", straight, 6m
max, threaded both ends
Cap
Procedure
1.
Using the flange [a] as a template, mark
hole locations on ceiling for four bolts.
Remove the flange and drill four .64cm
*
(1/4") holes to required depth.
For each hole, screw two nuts onto the
anchor bolt provided, with two threads of the
second nut extend- ing over end of the bolt
to protect the bolt threads from damage [b].
Hammer the bolt into ceiling leaving only
its threads exposed. Remove the nuts and
bolt the flange to the ceiling using the flat
washers, lock washers and nuts supplied [c].
[a]
[c]
2.
Thread the straight pipe [d] (not supplied)
and nipple [e] into pipe tee [f]. Thread the
nipple of the entire assembly into flange [g].
*
U.S. Customary Measurements in italics are rounded off.
Q-6
THE WORLD LEADER IN LOSS PREVENTION
Q t y .
Part No.
1
1400-0069-01
1
1417-0040-01
1
1417-0041-01
4
2880-0011
1
CE supplied
1
0500-3964-01
[b]
6.1M
(20') MAX
30.4cm
(12")
35.6cm (14")
3.
Feed video and multiconductor cables [h]
through center hole of pipe tee and down
through the pipe. Note: Remove the Cinch-
Jones connector, if used, to enter pipe.
Slip the cap [i] onto the pipe, then thread
housing [j] onto the pipe. See chassis
installation on page Q-8.
[g]
[e]
[f]
6m (20') max
[i]
MAX
[h]
[d]
[j]
Advertisement
Table of Contents
