Table of Contents
Advertisement
Sensormatic
SENSORVISION SYSTEMS
Required Parts
Hard Mount
0351-0393-01
Description
Q t y .
"S" hook, open
Chain, Navy link
Eye bolt, 10-24 w/nut
Washer, flat, SS #10
Nut, locking, 10x24
Aluminum tape
Procedure
IMPORTANT:
Shipping box contains a
template—do not throw the template out.
1.
Using the template, scribe a 35.6cm
*
(14")
hole in the ceiling or tile. Cut out
the hole.
[d]
[b]
[a]
[f]
[c]
2.
Place a washer [a] over the eyebolt
supplied [b]. Insert the eyebolt into a
hole in the top of the housing and
secure using a washer and nut [c].
*
U.S. Customary Measurements in italics are rounded off.
Part No.
2
2897-0004
6
2898-0002
1
2882-0112
2
2848-8100-17
1
2838-9154-05
4 FT
3200-0115-01
[e]
20cm
(8")
3.
Using an S-hook, hang safety chain [d]
from a strong ceiling member and, using
a second S-hook, attach other end of the
chain to the eyebolt. Keep the chain as
taut as possible. Tighten both ends of
each S-hook.
KEEP CHAIN AS TAUT AS
POSSIBLE! CLOSE ENDS
OF EACH S-HOOK!
DO NOT USE SPRINKLER
OR FIRE CONTROL
SYSTEM SECURING THE
SAFETY CHAIN!
4.
Feed video and multiconductor cables [e]
through one of the two holes in the side of
the housing. Then cover all openings in
the housing with the aluminum tape
supplied.
5.
With the three mounting tabs [f] of the
housing in the up position, insert the
housing into the ceiling hole, then from
inside the housing bring the tabs down
and tighten their screws to secure. The
housing is now ready for chassis
installation (page Q-8).
SENSORVISION SpeedDome
39.4cm
(15.5")
MAX
Q-1
Advertisement
Table of Contents
