Table of Contents
Advertisement
Feed camera dome cables [h] through
mounting bracket (i).
Apply sealant [j] to threads of straight
pipe [k], then slip pipe over cable and
screw pipe into bracket.
Slip elbow [l] over cable and screw elbow
onto pipe. Once on, elbow opening should
face down. Note: Approximately 36cm (14")
of cable must exit elbow. If so, insert plug [m]
and seal with RTV.
Hook bracket [n] on threaded stud between
washer and base [o] while feeding excess
cable [p] back through hole in bracket. Level,
and tighten nuts [q] on both sides of base to
secure.
The mount is now ready for housing and
chassis installation. See page Q-16.
*
U.S. Customary Measurements in italics are rounded off.
[m]
[h]
*
[q]
SENSORVISION SpeedDome
[j]
[l]
[k]
[i]
36cm (14")
[o]
[n]
[p]
Q-13
Advertisement
Table of Contents
