Table of Contents
Advertisement
5.
Attach the skirt assembly or optional
bubble assembly [h] to the chassis by
inserting its T-lanyard into a slot [i] on the
chassis until both ends catch securely.
6.
To lock the chassis in the housing,
squeeze ejector pins [j] and swing the
chassis all the way up, while easing the
cables up through the access holes.
Release these pins into the remaining
corner receptacles.
EJECTOR PINS MUST BE
FULLY INSERTED IN
THEIR RECEPTACLES.
7.
Snap the four pins of the skirt (or bubble)
assembly into the four chassis
receptacles [k].
8.
To compensate for accidental jarring
during assembly, recalibrate the dome
as follows:
a.
At the console, call up the
dome address number.
b.
Press and hold the FAST key.
Then—in order—press and
hold the ZOOM OUT,
FOCUS FAR, and IRIS OPEN
keys.
When the dome begins to pan
and tilt, release the keys.
Once calibrated, which takes about
a minute, the dome is ready for use.
Installation is complete.
SENSORVISION SpeedDome
Q-9
Advertisement
Table of Contents
