Sensormatic
SENSORVISION SYSTEMS
Loss of All Lens Functions
What to check.
1.
Dome switches.
2.
Camera/lens board.
3.
Sprockets.
Q-24
THE WORLD LEADER IN LOSS PREVENTION
What to do.
Ensure that the position of SW3 on S1 of the
RS422 interface board is set to OFF for
enabling lens functions.
Ensure that all connectors to and from the
camera/lens board are properly seated. If
that does not solve the problem, replace the
camera/lens board.
Check to see if the sprockets are hung up and
adjust them accordingly. If the motor gears
are too tight, adjust the gaps of the sprockets
and gears with a 1/4 watt resistor lead. See
page Q-37.