Table of Contents
Advertisement
Place plate [a] in desired loca-
tion, level, and mark slots. Plate
MUST BE LEVEL. Remove tem-
plate, then drill four 1/2-inch
holes to the required depth for
type of wall and hardware used.
For each hole into solid concrete, screw two nuts
[b] onto an anchor bolt, with two threads of second
nut extending over end of bolt to protect threads.
Hammer bolt into wall leaving 1-1/4 inch exposed.
Remove nuts and attach a 1/2-inch flat washer [c],
lock washer [d] and nut [e]. If voids are
encountered, see NOTE below.
Slip slots of mounting plate [f] over bolts,
togglers, or rods [g] and secure using proper
hardware. Mount base [h] to the plate using
hardware provided—any set of four studs can be
used. Feed cables through bottom of bracket [i].
Slip smooth-end of pipe [j] over cable and into
bracket. Secure pipe by tightening screw [k] and
level by adjusting nuts [l]. If using a decorative
cover [m], slide it over pipe.
Apply pipe sealant to pipe threads [n], then slip
elbow [o] over cable and screw elbow onto pipe.
Once on, elbow opening should face down.
Note: Approximately 36cm (14") of cable must
exit elbow. The mount is now ready for housing
and chassis installation on page Q-16.
NOTE: Voids encountered while drilling...
One void only:
Insert toggler (provided) through
hole where void ocurred. Insert associated bolt.
A
INSERT
metal
channel
thru hole.
B
PULL
plastic
tab to
seat
channel
C
SLIDE
plastic
cap along
tab until
seated
on wall.
D
SNAP off
plastic
legs at
cap by
pushing
outward.
TOP
[a]
[j]
[m]
Cover
(optional)
[i]
[k]
Two or more voids:
through wall. Then, insert threaded rod (provided)
through hole and attach hardware shown. Purchase
additional rods/hardware as required.
MOUNTING BRACKET
GOES HERE
Lock
Washer
Nut
1/2 inch
Flat Washer
SENSORVISION SpeedDome
[c]
[d]
[e]
[b]
[n]
[o]
36cm (14")
[f]
[g]
[a]
[l]
For each void, drill hole
1/2 inch
Flat Washer
Nut
3/4 inch
Flat Washer
Q-11
Advertisement
Table of Contents
