Table of Contents
Advertisement
WARNING:
and tilt can cause injury or
damage the dome during
servicing. To prevent such
movement, always disconnect
power/data connector P4 from
the RS422 interface board
before servicing.
AREA OF DETAIL
Male Connector
Bend
To slip ring
connector at
yoke bracket.
To J5,
cam./lens bd.
Cable Assy.
0650-0623-01
Female
[g]
Connector
1.
Remove the lens and camera shrouds (four
screws each). Next, detach the old clock-
spring cable by unplugging it from the J5
connector on the camera/ lens board [a] and
by removing two M3x10 screws [b] securing it
to the base of the yoke bracket. Then unplug
the cable from the slip ring connector [c],
unwind it, and slip it out of the retainer/spool
assembly [d].
2.
The new cable has an inked marking [e] on
it. Crease the cable along this marking to
form a 90° bend. Holding the cable's male
connector [f] in your hand, insert the bend
into the retainer as shown in the detail.
Unexpected pan
[f]
[e]
Retainer/
Spool Assy.
[d]
[b]
[a]
[c]
3.
Connect the cable's male connector to the
slip ring connector at the base of the yoke
bracket and secure it using the previously
removed screws. Dress the cable's female
end [g] clockwise around the spool approx-
imately 1-
times and connect its con-
1/2
nector to J5 on the camera/lens board.
4.
Reassemble the lens and camera shrouds
using the eight screws. CABLE REPLACE-
MENT IS COMPLETE.
5.
Reassemble the SpeedDome chassis and
recalibrate.
SENSORVISION SpeedDome
IMPORTANT:
It is not necessary
to disassemble the
eyeball assembly
from the carriage
assembly to
perform this task.
Eyeball assembly is
shown
disassembled for
explanation
purposes only.
Q-39
Advertisement
Table of Contents
