Table of Contents
Advertisement
Sensormatic
SENSORVISION SYSTEMS
Required Parts
Over Roof Install Kit
0351-0279-01
Description
Fitting, 90° pipe
Anchor bolt, 1/2x5 1/2"
Anchor, hollow wall, w/ P
Bolt, hex 1/2-13x4"
Washer, lock1/2"
Cable tie, Nylon, 7.5"
Rod, thread 1/2-13x18"
Nut, Hex 1/2-13"
Washer, flat, SS, P, .531ID X 1.25OD
Washer, flat, ST, Z, .812ID X 2.0OD
RTV compound
Pipe sealant
Washer, flat 5/16"
Nut, hex 5/16-18"
Bolt, hex 3/8-16x3/4"
Adaptor, BNC, male to female
Nut, hex, 1.5" pipe w/seal
Other Parts/Assys
Plate, mounting
Bracket, mounting
Base wall/pole mount
Arm, mounting outdoor
Cover, base (optional)
Procedure
Mounting to a solid wall:
[a] to a solid wall or poured concrete cap, where possible.
Mounting to a parapet:
a parapet is preferred. Typically, for the bubble to
clear, mount the base within:
*
25cm (10") of the top of the parapet.
•
A parapet with a 5cm (2") lip is shown [b].
13cm (5") from the corner of the building [c].
•
Mounting area (including clearance):
Minimum 33cm (13") x 48cm (19").
Note:
If the above requirements cannot be
met, mount the dome to the outside of the
wall (a decorative cover can be purchased to
enhance the look of the base). Alternately,
*
U.S. Customary Measurements in italics are rounded off.
Q-10
THE WORLD LEADER IN LOSS PREVENTION
Q t y .
Part No.
1
0500-3499-01
4
2880-0049
3
2880-0074-01
1
2880-8917-01
4
2847-0300
10
6009-0005
1
0500-2734-01
2
2838-9117-04
2
2848-8101-11
1
2848-1409-16
1
1600-0001
1
1600-0095-01
8
2848-6301-02
8
2838-9116-01
2
2880-0082-01
1
2113-0004
1
1417-0042-01
1
0500-3637-01
1
0500-3638-01
1
0500-3463-01
1
0200-0173-01
1
0500-3668-01
Mount bracket assembly
Mounting to the inside of
(continued on page Q-11)
a 10-inch extender can be screwed into the
end of the pipe, but tell the customer that
increased vibration from wind gusts may
result.
[b]
5cm (2")
[a]
(side view)
[c]
13cm (5")
Max
(top view)
25cm (10")
8cm (3")
Max
Advertisement
Table of Contents
