WARNING:
and tilt can cause injury or
damage the dome during
servicing. To prevent such
movement, always disconnect
power/data connector P4 from
the RS422 interface board
1.
Disconnect power supply cables from P5 [a]
on the RS422 interface board and from P2 [b]
on the dome CPU board.
2.
Cut the tie wraps [c] to release the
cables from the chassis.
3.
Detach the supply by removing four
M3x10 screws [d] from the corner tabs.
4.
Attach the new supply to the chassis
using the four screws previously
removed. Then secure its cables along
the chassis, as shown, using six new tie
wraps.
5.
Plug the cable having the large connector into
P5 on the RS422 interface board and the other
cable into P2 on the dome CPU board.
POWER SUPPLY REPLACEMENT IS COMPLETE.
6.
Reassemble the SpeedDome chassis and
recalibrate.
Unexpected pan
[a]
[b]
[c]
6 Places
Power Supply
5606-0002-02
SENSORVISION SpeedDome
[d]
Q-41