Table of Contents
Advertisement
Sensormatic
SENSORVISION SYSTEMS
WARNING:
and tilt can cause injury or
damage the dome during
servicing. To prevent such
movement, always disconnect
power/data connector P4 from
the RS422 interface board
Remove the lens and camera shrouds (four screws each). Then
remove the motor suspected of being defective. Tilt, zoom, focus
and iris motors secure to the eyeball casting using two M3x10
screws each. The pan motor secures to the carriage assembly.
Refer to the notes and diagrams for exact motor placement.
Note: Outline the bracket of the old motor with a pencil
before removing to simplify the alignment of the new motor.
Note: When installing screws in the zoom, focus and
iris motors, use the round hole [a] to align the motor,
then use the oblong hole [b] to adjust the gear mesh.
Note: Calibrate gear mesh using a 1/4-watt
resistor or .05mm (.02") dia. drill rod.
Note: Zoom, focus and iris motors are identical
and can be exchanged when troubleshooting.
Unless only the pan motor was replaced, reassemble
the lens and camera shrouds using the eight screws.
Then reassemble the SpeedDome chassis and
recalibrate.
Q-38
THE WORLD LEADER IN LOSS PREVENTION
Unexpected pan
Zoom Ring
Focus Ring
Pan Motor
3501-0009-01
Zoom Motor
3501-0008-01
Iris Ring
Tilt Motor
3501-0010-01
Iris Motor
3501-0008-01
[a]
[b]
Focus
Motor
3501-0008-0
Advertisement
Table of Contents
