Table of Contents
Advertisement
Sensormatic
SENSORVISION SYSTEMS
1
[a]
[b]
Using tamper-proof tool
(T-20), remove captive
bubble attachment screws [a]
from housing, then remove
bubble [b].
4
Next, connect the composite cable
compression connector [k] to J2, and the video
connector to J1, on the Outdoor Interface
Board [l], mounted on the outside of the
bracket. Make sure when connecting to this
board, that the screws of the compression
connector are turned toward the inner black
assembly. Tie wrap the composite cable to the
bracket assembly to make way for chassis
installation.
Q-16
THE WORLD LEADER IN LOSS PREVENTION
2
[c]
[d]
[f]
[g]
[h]
Screw 1.5" hex nut [c], with its white (or
yellow) seal facing the cap [d], onto the
pipe. Next, apply pipe sealant [e] to
threads of elbow (or nipple, if this is a
ceiling mount). Then feed the compo-
site cable (f) through the SpeedDome
cap [d] and through the housing [g].
Thread the dome housing onto the
elbow (or nipple), compressing the cap
against the housing until tight. Level as
shown [h]. Apply RTV around the hex
nut.
5
[l]
[k]
3
[e]
FEMALE
COMPRESSION-TYPE
CONNECTOR
PN 2109-0254-06
Existing composite cable
Referring to the chart below, replace
the Cinch-Jones connector [i] with
female compression connector [j]
(located at P4 on the SpeedDome
chassis).
Female Compression-Type
PI
1
2
3
4
5
6
7
[n]
[m]
[j]
1
7
[i]
from J-Box
Connector
PIN CONNECTIONS
DESCRIPTION
brown
data out (Lo)
yellow
data out (Hi)
black
ac
red
Gnd.
white
ac
green
data in (Lo)
orange
data in (Hi)
Snap the ball of
the lanyard [m]
in- to the
bracket [n] at
the top of the
housing.
(continued on page Q-17)
Advertisement
Table of Contents
