Primary-Secondary Set Up - ADJ Startec Series User Manual

Stinger Spot
Primary-Secondary Operation: This function will allow you to link up to 16 units together and oper-
ate without a controller. The units will be sound activated. In Primary-Secondary operation one unit
will act as the controlling unit and the others will react to the controlling units programs. Any unit can
act as a Primary or as a Secondary.
1. Using approved DMX data cables, daisy chain your units together via the XLR connector on the
rear of each unit. Remember the male XLR connector is the input and the female XLR connec-
tor is the output. The first unit in the chain (primary) will use the female XLR connector only, and
the last unit in the chain will use the male XLR connector only. For longer cable runs, the use of a
terminator on the last fixture is strongly recommended.
2. On the primary unit, press the MENU button until "SCND" is displayed, and press ENTER. Use
the UP and DOWN buttons to scroll to the "PRI" setting and press ENTER.
3. After setting the primary unit to the primary setting, configure the primary unit to the desired op-
erating mode.
4. On the secondary units, press the MENU button until "SCND" is displayed, and press ENTER.
Choose either "Sec1" or "Sec2" and press ENTER. See the System Menu section for more infor-
mation.
5. The secondary units will now follow the primary unit.
ADJ Products, LLC - www.adj.com - Stinger Spot User Manual Page 16

Primary-Secondary Set Up