ADJ Startec Series User Manual page 12

Stinger Spot
LOST - In the event that the DMX signal is lost, interrupted, or power is lost, this mode defines
how the fixture will behave until power or communication is re-established.
1. Press the MENU button until "LOST" is displayed, and either "HOLD", "SHND", or "BLAC" will be
displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to choose
an operating mode you would like the unit to start up in when power is applied or the DMX signal
is lost.
• Hold - If the DMX signal is lost, the fixture will stay in the last DMX setting. When power is ap-
plied, the unit will automatically default to the last DMX set up before power was disconnected.
• SHND (Show Mode) - If the DMX signal is lost or interrupted, the unit will automatically go into
show mode.
• BLAC (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into stand-
by mode.
3. Press ENTER to confirm your desired setup.
SOUN - Sound Active mode.
1. Press the MENU button until "SOUN" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to
activate sound active mode, or "OFF" to deactivate sound active mode.
3. Press ENTER to confirm.
SENS - In this mode you can adjust the sound sensitivity.
1. Press the MENU button until "SENS" is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the sound
sensitivity. 0 being the least sensitive, and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to confirm.
PINT - Pan Inversion
1. Press the MENU button until "PINT" is displayed, press ENTER. Either "Yes" or "No" will be
displayed.
2. To activate the Pan inversion press the UP or DOWN buttons until "Yes" is displayed, and press
ENTER to confirm. To deactivate Pan inversion, select "No" and press ENTER.
TINT - Tilt Inversion
1. Press the MENU button until "TINT" is displayed, press ENTER. Either "Yes" or "No" will be
displayed.
2. To activate the tilt inversion press the UP or DOWN buttons until "Yes" is displayed, and press
ENTER to confirm. To deactivate tilt inversion, select "No" and press ENTER.
LED - With this function you can have the LED display turn off after 10 seconds.
1. Press the MENU button until "LED" is displayed, and press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to
keep the LED display on at all time, or "OFF" to set the LED display to switch off after 10
seconds.
3. Press ENTER to confirm.
ADJ Products, LLC - www.adj.com - Stinger Spot User Manual Page 12
System Menu