System Menu - ADJ Startec Series User Manual

Stinger Spot
System Menu: When making adjustments press ENTER to confirm your setup then press and
hold the MENU button for at least 3 seconds. To exit without making any adjustments press
the MENU button. The display will lock after 30 seconds, press the MENU button for 3 seconds
to unlock.
ADDR - DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until "ADDR" is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find
your desired address. Press ENTER to set your desired DMX address.
CHND - This will let select your desired DMX channel mode.
1. Press the either the MENU button until "CHND" is displayed, press ENTER. Either "9CH" or
"11CH" will be displayed.
2. Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to
confirm and exit.
SHND - Show modes 0-4 (Factory programs). Show mode can run with or without sound active
mode active.
1. Press the MENU button until "SHND" is displayed, press ENTER.
2. "Sh X" will now be displayed, "X" representing a number between 0-4. Shows 1-4 are factory
programs, while show "0" is random mode.
3. When you have found your desired show press ENTER, then press and hold the MENU button for
at least 3 seconds to activate. After you have set your desired show, it can be changed at any
time using the UP or DOWN buttons.
DIND - This will let select your desired dimmer curve.
1. Press the either the MENU button until "DIND" is displayed, press ENTER. 1 of 5 dimmer curves
will be displayed. "STDA" (standard), "STGE" (stage), "TV" (TV), "ARAL" (theatrical), or "THAL"
(Architectural).
2. Press the UP and DOWN buttons to find your desired dimmer curve and press ENTER to confirm
and exit.
SCND - This will let you set unit as the primary or secondary device in a primary/secondary
configuration.
1. Press the MENU button until "SCND" is displayed, press ENTER. Either "PRI", "SEC1", or "SEC2"
will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, press ENTER to confirm.
NOTE: In a primary/secondary configuration, you can set one fixture to "PRI" and then set the next
fixture to "SEC2", the fixtures will now have contrasting movements to each other.
ADJ Products, LLC - www.adj.com - Stinger Spot User Manual Page 11

System Menu