Wifly Set Up I Wifly Master-Slave I Runtime Mode - ADJ SABER SPOT GO User Instructions

Saber Spot GO
This unit can only be controlled using WiFly. Your DMX controller must be connected to a ADJ WiFly
Transceiver to use this function. You are able to communicate up to 2500 feet/760 meters (open line
of sight).
1. Follow the instructions on page 18 to set the WiFly channel. The channel must match the channel
setting on the WiFly WiFly Transceiver.
2. After you have set the WiFly channel, follow the DMX instructions on page 16 to select your
desired DMX Channel mode and set your DMX address.
3. Apply power to the ADJ WiFly Transceiver. The fixture must be set up first before you apply
power to WiFly Transceiver.
4. If everything is set up properly and the fixture is receiving a wireless signal, you should now be
able to control it with a DMX controller.
Saber Spot GO
This function will allow you to link units together via WiFly to run in a Master-Slave setup.
1. Follow the instructions on page 18 to set the WiFly channel. The channel on each fixture must be
the same.
2. After you have set the WiFly channel, select your "Master" unit and set your desired operating
mode.
3. On the slave units press the MODE button until "Slave" is displayed.
4. The slave units will now follow the Master unit.
Saber Spot GO
[2hours] - When the battery is at full charge and running full on, the battery will run for at least 2
hours at 14W. LCD display will show "2hours".
[4hours] - When the battery is at full charge and running full on, the battery will run for at least 4
hours at 7W. LCD display will show "4hours".
[6hours] - When the battery is at full charge and running full on, the battery will run for at least 6
hours at 4.9W. LCD display will show "6hours".
[8hours] - When the battery is at full charge and running full on, the battery will run for at least 8
hours at 3.9W. LCD display will show "8hours".
ADJ Products, LLC - www.adj.com - Saber Spot GO User Manual Page 19
WiFly Set Up
WiFly Master-Slave Set Up
Runtime Mode