Checking The Restricted Air-Cleaner Indicator; Inspecting The Machine - Toro 25450W Operator's Manual

1. Fill cap (off)
2. Hydraulic fluid
Note: The hydraulic-fluid level should be between the
bottom and midpoint of the sight glass.
4. If the hydraulic-fluid level is not visible in the sight
glass, remove the fill cap
hydraulic fluid until the fluid level is at the midpoint of
the sight glass, and install the fill cap.
Checking the Restricted
Air-Cleaner Indicator
Service Interval: Before each use or daily
1. Start the engine; refer to
2. Check to see if the restricted air-cleaner indicator is
displayed in the home screen of the command center
(Figure 27).
Figure 26
3. Hydraulic fluid level at the
midpoint of the sight glass
(Figure 26), add the specified
Starting the Engine (page
1. Restricted air-cleaner
indicator
3. Replace the air-cleaner element(s) as follows:
A. Replace the primary air-cleaner element; refer to
Replacing the Air-cleaner Elements (page
B. Repeat steps
C. If the restricted air-cleaner indicator is still
displayed, replace the secondary air-cleaner
element; refer to
Elements (page

Inspecting the Machine

Service Interval: Before each use or daily
Inspect the following items on the machine each day before
you start the engine:
•
Check for leaks under the machine, and repair all leaks.
•
Check the tires for wear, damage, and low pressure.
•
Check the machine for debris, especially around the
engine.
33).
Note: Ensure that the area near the engine is clean so
that the engine cools properly.
•
Clean or replace any safety or instructional decal that you
cannot read.
•
Clean machine components that you use.
•
Remove any loose items from the machine.
•
Check the machine for broken, damaged, loose, or
missing parts. Replace, tighten, or adjust these parts
before you operate the machine.
•
Repair or replace all damaged ROPS and seat belt parts.
27
Figure 27
2. Command center
1 and 2.
Replacing the Air-cleaner
49).
49).