Install The Radio & Servos - Tower Hobbies Tower Kaos 40 MKII Manual

9. Locate the .074 x 16" [406mm] pushrod, threaded on
one end. Thread a nylon clevis onto the threaded portion of
the rod approximately 20 full turns. Install a silicone clevis
keeper onto the bottom of the clevis.
10. Slide the end of the wire into the tube. Attach the clevis
to the throttle arm on the carburetor. Slide the clevis keeper
over the clevis.
11. Install the muffler. Attach the fuel lines to the
carburetor and the muffler pressure tap.
12. Install the appropriate propeller for your engine and
the spinner onto the engine crankshaft.
INSTALL THE RADIO & SERVOS
1. Install your servos into the servo bay using the hardware
and instructions that came with the servos. Install the servos
in the direction shown. You will only need to use a servo arm
that has three holes in the arm. If your servo arms have more
than 3 holes, cut off the excess holes and shape the end of the
arm to a round finish with a sanding block or high-speed
rotary tool. Cut off the unused arms. Set them aside as you
will be using some of them later.
2. Locate the three 2 x 680mm wire pushrods, threaded on
one end. Thread a nylon clevis onto the threaded portion of
the rod approximately 16 to 20 full turns. Install a silicone
clevis keeper onto the bottom of the clevis. Install the clevis
into the nylon control horn. Once it is securely in place slide
15