Tower Hobbies Tower Kaos 40 MKII Manual page 13

7. The nylon steering arm has three holes. Cut the end hole
from the steering arm. Using a small sanding block, round the
end of the arm after cutting off the outermost hole.
8. Locate the 1.5mm wire with the Z-bend on one end of
the wire. Insert it into the outermost hole of the steering arm
as shown.
9. Locate the wire nose gear. Notice that there is a flat spot
on one side of the wire. Insert the wire through the bottom of
the fuselage, through the nylon nose gear bearing, the nylon
steering arm and into the bottom of the engine mount. Apply
a drop of threadlocker to the set screw. Then, tighten the set
screw in the steering arm onto the flat spot on the landing
gear wire.
10. File a flat spot onto the end of the metal nose gear wire.
11. Locate two 4mm wheel collars and two 3 x 5mm set
screws. Install the screws into the wheel collars. Slide a wheel
collar and set screw onto the nose gear wire, followed by the
foam nose wheel and another wheel collar and set screw.
Tighten the set screw in the outer wheel collar onto the flat
spot you filed on the end of the wire. Center the nose wheel
and then tighten the set screw on the remaining wheel collar.
13