Table of Contents
Advertisement
Blank panel
1. Raise the blank panel. (Refer to the "Ornamental
plate".)
2. Loosen the two coin head screws of the slider (LH)
assembly and of the slider (RH) assembly by turning
them in the direction of arrows A and B. Remove the
blank panel by moving it in the direction of arrow C.
n
When installing the blank panel back to the MAV-
555A, raise the right end and the left end of the slider
assembly to the same height (three to four clicks
upwards) and install the blank panel.
Blank panel
C
Coin head screw
Slider (LH)
B
assembly
Blank panel
MAV-555A
Slider (RH)
Holes
assembly
A
Claws
Coin head screw
Adjusting the force to open and close the blank panel
The blank panel of the MAV-555A is equipped with the
adjustment screws in its right end and left end that deter-
mine force to open and close the blank panel. Turing the
adjustment screws clockwise increases the force and
turning them counter-clockwise reduces the force. The
screws can be rotated in the range of 90d to 180d. Adjust
the force as desired.
n
Do not open or close the blank panel with the adjustment
screws rotated fully clockwise.
Adjustment screw
90d to 180d
Loosens
Adjustment screw
3-2. Removing the Cabinet
Adjustment
Tightens
screw
3-3 (E)
Advertisement
Table of Contents
