Table of Contents
Advertisement
1-2. Acquiring the Logs
Connection (excluding PU-121 board)
Connect the Ethernet terminal of the rear panel to a personal computer using an Ethernet cross cable.
Preparation
1. Set the IP address and the sub-net mask of the MAV-555A to the factory settings.
m
. The IP address and sub-net mask can be confirmed in set-up menu No. 220.
. The factory settings are as follows:
IP address :
192.168.0.1
Sub-net mask : 255.255.255.0
2. Set the IP address and the sub-net mask of the personal computer as follows:
IP address :
192.168.0.2
Sub-net mask : 255.255.255.0
3. Start up the personal computer.
4. Wait for the MS-DOS prompt (or command prompt) to appear.
5. Input [ping 192.168.0.1].
Microsoft(R) Windows 95
(C)Copyright Microsoft Corp 1981-1995.
C:\>ping\192.168.0.1"
6. Confirm that the reply is returned normally.
Message example (normally)
C:\>ping\192.168.0.1"
Pinging 192.168.0.1 with 32 bytes of data:
Reply from 192.168.0.1: bytes=32 time=2ms TTL=254
Reply from 192.168.0.1: bytes=32 time=1ms TTL=254
Reply from 192.168.0.1: bytes=32 time<10ms TTL=254
Reply from 192.168.0.1: bytes=32 time=1ms TTL=254
C:\>
Message example (abnormally)
C:\>ping\192.168.0.1"
Pinging 192.168.0.1 with 32 bytes of data:
Request timed out
Request timed out
Request timed out
Request timed out
C:\>
7. If the reply is not returned normally, input [arp -d 192.168.0.1] and perform from step 5 again.
(There can be a case that the APR table information is left remained when two or more MAV-555As
are connected continuously.)
1-4 (E)
MAV-555A
Advertisement
Table of Contents
