To Install A Pc Card - Agilent Technologies J2300D System Manual

6
Using Modem & Ethernet PC Cards

To Install a PC Card

NO TE
PC Card Slots
46
1 Slide the PC Card in the PC Card slot until you feel some
resistance. All PC Cards are keyed for correct installation.
The card's label will typically face up or will explain which
side is up.
2 Push firmly, but gently, to ensure a good connection. Never
attempt to force the card into position.
3 Listen for an audible double-beep tone within five seconds,
confirming that the system recognizes a PC Card has been
inserted.
When using the alternate boot selection (in MS-DOS mode) or when you
have a Gigabit Ethernet undercradle attached, install your PC Card before
you turn on the Advisor.
Front
4 To verify that the system has properly identified the card,
check the system properties of the installed PC Card. On the
desktop, right click on My Computer and select Properties.
From the System Properties window, select the Device
Manager tab, select your PC Card device category, and
double-click on the PC Card description. From there you can
check either General or Resources information.
Release Buttons
Advisor Mainframe Features System Guide