3
Installing/Removing Interface Modules
Installing Interface Modules
CAU TI O N
28
There are several Interface Modules and one Filler Panel
available for use with the Advisor. The Filler Panel acts as a
cover for the Interface Module slot when no Interface Module is
installed.
You can install interface modules directly into the mainframe or
into a compatible undercradle. Refer to Chapter 1 for supported
Interface Module configurations with the Advisor and
Undercradles.
Make sure you turn off the power and unplug the Advisor before attaching
or removing undercradles.
1 Make sure the Module Release Latch is in the Install/Remove
Position.
2 Slide the Interface Module or Filler Panel into the opening.
3 Push it firmly into place until it is seated and the Module
Release Latch moves to the Locked Position. The Module
Release Latch does not move when you install a Filler Panel.
You will need to push the Module Release Latch to move the
latch into its locked position.
Advisor Mainframe Features System Guide