Re-Assembling The J2295A Undercradle - Agilent Technologies J2300D System Manual

Re-assembling the J2295A Undercradle

Advisor Mainframe Features System Guide
1 Place the top back on the undercradle, aligning the slot in the
top with the Advisor connector. Fasten with the four
flat-head screws.
2 On the side nearest to the Advisor connector, slide the left
side piece into place and secure it with four pan-head screws
(two on the top and two on the bottom). If you are only
installing one printed circuit card, insert the small flat
endcap in the left side piece before you put it on the
undercradle.
3 If you are installing full-length printed circuit cards, insert
the endcap expander into the right side before you place it on
the undercradle. If you are installing smaller printed circuit
cards, insert the flat metal endcap in the right side before
you place it on the undercradle.
4 Slide the undercradle right side piece into place and secure it
with four pan-head screws (two on the top and two on the
bottom).
5 Turn the undercradle over and replace the four black rubber
feet into the foot indentations.
Attaching/Removing Undercradles
4
37