MIDI Program Selection
The QuadraVerb GT responds to MIDI program change commands.
Therefore, sending a particular program number via MIDI to the
QuadraVerb GT will call up the program you specified.
If a device can generate program change commands, patching its MIDI
Out to the QuadraVerb GT's MIDI In allows for remote program
selection.
Several devices can generate program change commands:
¥ MIDI footswitch This is probably the option that most guitarists will
use. A MIDI footswitch sends program changes in response to
footswitch presses. Many companies make MIDI footswitches; their
manuals explain how to program the footswitch to send out
particular program changes.
¥ MIDI sequencer A sequencer can record and play back MIDI data,
including program change commands.
¥ Synthesizer Selecting a new program on a synthesizer usually sends
out a corresponding program change command. This allows any
signal processor hooked up to the synth to change its settings in
response to different synth programs.
¥ Other effects boxes If you use more than one effects box, calling up a
program on it will often send a corresponding program change
through its MIDI Out.
NOTE: Your QuadraVerb GT and the MIDI footswitch must both be set to
the same MIDI channel to execute program changes.
MIDI In
MIDI Out
Footswitch
11