Adjusting The Sample Mix Parameters - Alesis GT Reference Manual

This page determine the length of the sample playback.
4. Use the VALUE buttons to select the desired sample length time.

Adjusting the Sample Mix Parameters

The Mix module allows for adjusting the relative balance between the
direct signal, and the recorded sample playback signal.
1. Press the MIX button. The display says:
This page controls the level of the direct signal.
2. Press the VALUE buttons to select the desired direct signal level. The
range is 0 to 99 (0 is off).
3. Press the PAGE UP button to select the next page. The display says:
This page controls the sampleÕs output level.
4. Press the VALUE buttons to select the desired preamp signal level.
The range is 0 to 99 (0 is off).
5. Press the PAGE UP button to select the next page. The display says:
This page controls the sampleÕs output level.
6. Press the VALUE buttons to select the desired recorded Sample signal
level. The range is 0 to 99 (0 is off).
DIRECT LEVEL:
5 0
PREAMP LEVEL:
5 0
PLAYBACK LEVEL:
5 0
96