Select The Midi Trigger Note - Alesis GT Reference Manual

¥ Off The QuadraVerb GT will not respond to MIDI note on/off
information).
¥ MIDI One Shot The recorded sample will play back to the selected
end of the sample, regardless of how long the key is pressed.
IMPORTANT: If the playback mode is set to "Looping" and MIDI Trigger
is set to One Shot, the sample will play indefinitely until the mode is
changed or the sampling configuration is deselected. MIDI Trigger and
Sample Playback mode need to be set to the same value (either both
Looping or both One Shot.)

Select the MIDI Trigger Note

1. Assuming the DELAY module is selected, use the PAGE buttons to
select the display that says:
2. Press the VALUE UP button to select the lowest note that can trigger
the recorded sample. (Note number 60 = Middle C.)
3. Press the PAGE UP button. The next display says:
4. The Base value is the note where the sample plays back with no pitch
change. Press the VALUE buttons to select the desired note.
5. Press the PAGE UP button. The next display says:
6. Press the VALUE DOWN button to select the highest note that can
trigger the recorded sample.
MIDI TRIGGER
LOW LIMIT: 0 00
MIDI TRIGGER
BASE: 0 60
MIDI TRIGGER
HIGH LIMIT: 0 60
94