Now, step on the pedal until it is all the way forward. Set the Mod
Amplitude level to its maximum value (+99). This sets the amount of
Reverb Output level you will hear when the pedal is completely
forward. By assigning these two values to the extreme positions of your
controller's range, you have defined the range within your target
parameter that you will be able to modulate with the controller.
7.3 TARGET PARAMETER LISTING
Here is a listing of available target parameters for all configurations
except Configuration 8 (sampling), which has no target parameters.
Some of the target parameters are dependent on a previously selected
page. For example, the Reverb Decay parameter in configuration 1
becomes Reverb Reverse Time when the Reverb Type page has been set
to Reverse (see below). The indented bold headings signify which
parameter or mode must be selected to yield the target parameters that
follow it.
Configuration 1 Target Parameters
Reverb Input Mix
Reverb Predelay
Reverb Predelay Mix
Reverb Type: Reverse
Reverb Reverse Time
Reverb Diffusion
Reverb Density (not available for Reverb Type: Hall 1)
Reverb Low Decay
Reverb Hi Decay
Delay Input Mix
Delay Type: Mono Delay
Delay Time
Delay Feedback
Pitch Mode: Pitch Detune
Detune Amount
Reverb Type: All Others
Reverb Decay
Delay Type: Stereo Delay
Left Delay Time/Right Delay Time
L Delay Feedback/R Delay Feedback
Pitch Mode: All Others
LFO Speed
LFO Depth
Pitch Feedback
107