Resonator Amplitude (Resonators + Eq Mode Only); Low Eq Frequency (3 Band Eq Mode Only); Low Eq Amplitude (3 Band Eq Mode Only) - Alesis GT Reference Manual

Resonator Amplitude (Resonators + EQ mode only)

The display says:
This sets the volume level for resonator 1. The higher the number, the
louder the output of the resonator. Please note that if both resonators are
assigned a value of 00, you will not hear any sound in this configuration.
Pressing the PAGE up button will show the Tune, Decay, and Amplitude
pages for Resonator 2.

Low EQ Frequency (3 Band EQ mode only)

The display says:
This sets the frequency below which all signals will be boosted or cut by
the amplitude amount set on the next page.

Low EQ Amplitude (3 Band EQ mode only)

The display says:
This sets the amount of boost (positive numbers) or cut (negative
numbers) at the Low EQ Frequency set on the previous page.
RESONATOR 1 AMP:
9 9
LOW EQ FREQUENCY
2 00Hz
LOW EQ AMPLITUDE
+ 0 0.00dB
58