5.6.3. Quick change of other parameters
In order to quickly change of other parameters of the program, press the icon
Select the parameter you want to change and make changes by strolling the list up or down
Confirm the change by pressing
Figure 19 - Quick change of other parameters
Statistics
5.7.
This panel displays statistics about the currently running program or program that has ended. Statistics are
calculated separately for each segment and for a current cycle. Data logging starts for calculation after 30
seconds from reaching the set temperature in the segment. The next data is registered every 1 minute.
The following information is available:
•
Set temperature [°C] – set temperature in the segment
•
Minimum temperature [°C] – the lowest recorded temperature
•
Maximum temperature [°C] – the highest recorded temperature
•
Average temperature [°C] – average temperature
•
Segment – status of the segment
In progress – currently performed segment (data is constantly updated)
-
finished – the segment is made,
-
interrupted – the segment was interrupted by the User before the set time expired
-
•
Segment 1/2 –the number of the currently overviewing segment / number of the currently performed
or completed segment. Navigating between the segments is done by swiping up your finger up or
down.
Instruction Manual DL, VL, IL
.
in main screen
(Figure
(Figure
19).
Page 28 / 49
2).