Stop The Engine And Switch Off; Repair - AL-KO solo HP50E-A Manual

Repair

WARNING! Danger from rotating appli-
ance parts! Reaching into rotating appliance
parts will result in serious injuries!
■
Never reach into rotating parts.
■
Before starting to use the engine, observe
the operating instructions for the appliance.
■
Only start and allow the engine to run out-
doors.
■
Do not tilt the machine so far to the side that
fuel runs out of the fuel tank cap.
■
Tie up long hair and remove jewellery.
■
Do not wear loose clothing.
■
Wear sturdy, non-slip shoes.
■
Do not change the basic setting of the engine
or over-rev.
■
Switch off the engine and allow to cool down
before removing the tank cap.
■
Switch off the engine, allow it to cool and re-
move the spark plug cable before checking,
cleaning or working on the machine or en-
gine.
■
Wait until the engine has cooled down suffi-
ciently before touching the cylinder ribs and
protective housing.
■
Do not rotate the engine without a spark plug.
5.1

Stop the engine and switch off

■
Observe the safety regulations when starting.
■
Position the engine unit safely and securely.
■
Stand securely.
NOTE Observe the operating instructions
for the appliance.
Starting the engine
CAUTION! Risk of injury! Danger of kick-
back: The starter cable can return faster to the
engine than the cable can be released.
■
Anticipate a sudden jolt when the starter ca-
ble has been pulled.
Position of the choke lever:
CHOKE
469996_a
If the engine is cold:
1. Set the stop switch to the START/ON posi-
2. Turn the choke lever (01/3) anticlockwise to
3. Press the primer (01/4) 5 to 10 times until the
4. Pull out the starter cable (01/2) briskly and
5. Turn the choke lever (01/3) clockwise to the
6. Warm up the engine at idling speed (see op-
When the engine is warm:
1. Set the stop switch to the START/ON posi-
2. Turn the choke lever (01/3) clockwise to the
3. Pull out the starter cable (01/2) briskly and
With the engine running:
■
■
■
Switching off the engine:
1. Set the stop switch to the STOP/OFF position
6 REPAIR
work. Improper repairs can lead to serious inju-
ries and damage to the appliance.
■
Only original spare parts of the manufacturer are
allowed to be used.
RUN
tion (see operating instructions of the appli-
ance).
CHOKE.
primer is filled with fuel.
then allow it to wind back in slowly.
RUN position.
erating instructions of the appliance).
tion (see operating instructions of the appli-
ance).
RUN position.
then allow it to wind back in slowly.
Do not place your hands and feet close to
any rotating parts.
Keep flammable objects from the exhaust
and the cylinder area.
Allow the exhaust, cylinder and cooling vanes
to cool down before contact.
(see operating instructions of the appliance).
WARNING! Risk of injury during repair
Repair work may only be carried out by ser-
vice centres of the manufacturer or by autho-
rised specialist workshops.
19